shop header graphic
shop header graphic
shop header graphic

10″ 4-OHM Subwoofer – XS10S

250 Watts Rms / 1000 Watts Peak
30oz. Magnet
4-ohm Impedance
Nitrile Rubber Surround
Heavy Duty Push Terminals

SKU: XS10S Category:

Specifications

Built for the Road Ahead

Your Jensen XS series subwoofers comes equipped with all the components that will may any drive more enjoyable. Your car subwoofer comes with a detailed instruction manual that will help you get setup and ready to go in no time. However, we do suggest professional installation to prevent any issues with your new Jensen subwoofer.

We made sure that at the time of installation you had everything you needed for a smooth upgrade. All JensenXS subwoofers comes with the essential hardware required to install them properly in your car.

Designed & Engineered in the USA

We are extremely proud to say that our Jensen car audio subwoofers are expertly designed and engineered right here in the USA using cutting edge equipment and technology.

Our engineers take into account several factors and perform numerous tests to ensure that the JensenXS subwoofer you receive is above your expectations. We aim to always provide innovative and long lasting products that provide continuous studio quality performance.

Reinforced Steel Basket

We take pride in only putting the very best in our JensenXS subwoofer lines. The addition of the reinforced low resonance basket and heavy-duty motor structure with 40oz magnet is to isolate unnecessary vibrations producing low resonance and accurate bass.

Endless Journeys

Lower your car windows with confidence with your JensenXS car subwoofer. You will now have up to 1400 Watts at your finger tips. Traveling the country is never the same without being able to listen to your favorite tunes so make sure that they are listening to them at the best auditory experience on the planet.

Built for the Road Ahead.

  • System Type 12″ Subwoofer
  • Impedance 4 ohms
  • Frequency Response 22Hz-250Hz
  • Total Peak Power 1400W
  • RMS Power 50-350W
  • Efficiency 1W / 1M 90dB
  • Efficiency 1W in-car 93dB
  • Xmax 10mm
  • Type Subwoofer
  • Diameter 12″
  • Woofer Cone Material Polypropylene
  • Woofer Surround Material NBR (Nitrile Butadiene Rubber)
  • Woofer Spider Nomex fiber blend with stitched leadwires
  • Vented Spider Yes
  • Woofer Voice Coil Diameter 2″ (51mm)
  • Woofer Magnet Weight 40oz.
  • Woofer Basket Stamped steel with textured black paint
  • Terminals 8ga. spring terminals
  • Tweeter Height (from mounting surface) N/A
  • Mounting Cutout 279mm (11.00″)
  • Mounting Depth 138mm (5.45″)
  • Fs 29 Hz
  • Qts (Total Q) 0.452
  • Qes (Electrical Q) 0.512
  • Qms (Mechanical Q) 3.90
  • Vas 112L (3.95 cu.ft)
  • DC Resistance 3.40 ohms
  • Driver Radiating Area 513 sq. cm (79.5 sq. in)
  • Volume Displacement 0.51L (0.018 cu. ft)
  • Mms 106g
  • Mmd 132g
  • BL 10.85

Documents

Manuals & More

XS10S


Click Here to Read Warning for California Residents