6” x 9” 3-Way Speakers


Built for the Road Ahead

Your Jensen XS car speakers come equipped with all the components that will make any drive more enjoyable. Your car speakers come with a detailed instruction manual that will help you get setup and ready to go in no time. However, we do suggest professional installation to prevent any issues with your new Jensen car speakers.

We made sure that at the time of installation you had everything you needed for a smooth upgrade. All Jensen XS car speakers come with all necessary hardware required to install them properly in your car.

Superior Technology & Design

Only top of the line components go into our line of Jensen XS car speakers including:

- 25mm and 13mm Low Mass Silk Dome Tweeters with silk imported from Japan it offers the smoothest high frequency response and life-like sound quality imaginable.

- Mica Filled Injection Molded Polypropylene Cones: for accurate bass response.

- Nitrile Rubber Surrounds: to withstand heat and moisture, prolonging the life of the speakers.

Endless Journeys

Lower your car windows with confidence with your Jensen XS car speakers. You will now have 280 Watts of Peak Power at 4 Ohm Impedance right at your finger tips. Traveling the country is not the same without being able to listen to your favorite tunes so make sure that you are listening to them at the best auditory experience on the planet.

Built for the Road Ahead.

In stock
Part Number


System Type    6" x 9" 3-Way Speaker
Impedance    4 Ohms
Frequency Response    32Hz - 35kHz
Total Peak Power    400W
RMS Power    100W
Efficiency 1W / 1M    91dB
Efficiency 2.83V / 1M    94dB
Xmax    4.5mm
Type    3-way
Diameter    6" x 9"
Tweeter    25mm silk dome
Supertweeter    13mm silk dome
Woofer Cone Material    Polypropylene w/ mica flake
Woofer Surround Material    NBR (Nitrile Butadiene Rubber)
Woofer Spider    Nomex fiber blend
Vented Spider    No
Woofer Voice Coil Diameter    1" (25mm)
Woofer Magnet Weight    20
Woofer Basket    Stamped steel with textured black paint
Terminals    0.205" and 0.110" tab
Grille    Yes
Grille Height    29mm (1.15")
Tweeter Height (from mounting surface)    11mm (0.43")
Mounting Cutout    150mm x 218mm (5.9" x 8.58")
Mounting Depth    85mm (3.35")