Firmware Update Instructions
A Note about Firmware Update via USB Devices
We recommend following the guidelines below for your USB drive:
- Use an 8GB or 16GB USB drive from a common USB drive manufacturer.
- Some recommended brands include:
- SanDisk®
- Kingston®
- PNY®
- Verbatim®
- Corsair®
- The drive should support USB 2.0 or faster transfer speeds. Older version USB 1.0 drives are not compatible.
- Format the drive using FAT32 as the file system on your laptop or computer before copying the software update to the USB drive.
* This update is for (Vers-A) only. Please check the sticker on the bottom of the screen. If it states (Vers-B) It will not accept or need the firmware update.
Firmware Update(s):
THIS UPDATE ADDRESSES THE FOLLOWING:
Updates the Safety Notice screen to disappear automatically after 2 seconds without touch confirmation. Also, a new UI with all icons on one page of the home screen.
Note:
1.Software is not interchangeable between models. Please do not attempt this update on any other model other than the JDASHCP.
2. Do not remove the USB stick until the radio says to do so. If removed during the update, the radio will be non-functioning.
JDASHCP-2U Firmware Download
Upgrade method:
1. Put all the files contained in the Software folder onto the USB thumb drive
2. Plug the USB thumb drive into the USB port of the JDASHCP on the back of the screen and click Confirm in the dialog box.
3. The update will begin automatically and continue to upgrade the APP and MCU.
4. Once the update has completed, click OK in the dialog box when it appears.
- Download the 3M Adhesive Installation Guide (EN/ES)
How to Improve Dashboard Mounting Strength
If the surface of your dash is not flat or has texture, please use the included plastic disc with 3M tape to improve dashboard mounting strength.
Clean the Surface:
Use a cleaning cloth to wipe down the surface where you want to attach the base. Ensure the area is free from dust and dirt for proper adhesion.
Peel the Adhesive:
Remove the protective film from the adhesive side of the pad to expose the sticky surface.
Place the Adhesive Pad:
Firmly press the adhesive pad onto the cleaned surface, making sure it's aligned as needed.
Attach the Suction Cup Mount:
Press the suction base of your device onto the adhesive pad, securing it in place for a stable hold.
Cómo mejorar la resistencia de montaje del tablero
Si su superficie del tablero no es plana o tiene textura, por favor utilice el disco de plástico incluido con cinta 3M para mejorar el apego de la taza de aspiración.
Limpie la superficie:
Use un paño de limpieza para limpiar la superficie donde desea colocar la base. Asegúrese de que el área esté libre de polvo y suciedad para une correcta adhesión.
Despegue el adhesivo:
Retire la película protectora del lado adhesivo de la almohadilla para exponer la superficie pegajosa.
Coloque la almohadilla adhesiva:
Presione firmemente la almohadilla adhesiva sobre la superficie limpia, asegurándose de que esta alineada según sea necesario.
Fije el soporte de succión:
Presione la base de succión de su dispositivo sobre la almohadilla adhesiva, asegurándolo en su lugar para una sujeción estable.
